However, in the case of schools you need to equip the bathroom in the right amount of sinks, where you will be able to wash their hands after using the toilet.In schools, sports can also stand up showers.
An elbow is a pipe fitting installed between two lengths of pipe or tubing to allow a change of direction, usually a 90° or 45° angle, though 22.5° elbows are also made.
The ends may be machined for butt welding, threaded (usually female), or socketed, etc.When the two ends differ in size, the fitting is called a reducing elbow or reducer elbow. Elbows are categorized based on various design features as below: Long Radius (LR) Elbows ? radius is 1.5 times the pipe diameter Short Radius (SR) Elbows ? radius is 1.0 times the pipe diameter 90 Degree Elbow ? where change in direction required is 90° 60 Degree Elbow ? where change in direction required is 60° 45 Degree Elbow ? where change in direction required is 45° A 90 degree elbow is also called a "90 bend" or "90 ell".
It is a fitting which is bent in such a way to produce 90 degree change in the direction of flow in the pipe.It is used to change the direction in piping and is also sometimes called a "quarter bend". A 90 degree elbow attaches readily to plastic, copper, cast iron, steel and lead.
It can also attach to rubber with stainless steel clamps.
The main application of an elbow (90 degree) is to connect hoses to valves, water pressure pumps, and deck drains.These elbows can be made from tough nylon material or NPT thread.Źródło: https://en.wikipedia.org/wiki/Piping_and_plumbing_fitting
The difference between pipes and tubes is simply in the way it is sized.
Copper tube, CPVC, PeX and other tubing is measured nominally, which is basically an average diameter.
These sizing schemes allow for universal adaptation of transitional fittings.
The schedule is largely determined by the operating pressure of the system, with higher pressures commanding greater thickness.Copper tubing is available in four wall thicknesses: type DWV (thinnest wall; only allowed as drain pipe per UPC), type 'M' (thin; typically only allowed as drain pipe by IPC code), type 'L' (thicker, standard duty for water lines and water service), and type 'K' (thickest, typically used underground between the main and the meter).
Because piping and tubing are commodities, having a greater wall thickness implies higher initial cost.
Thicker walled pipe generally implies greater durability and higher pressure tolerances.Źródło: https://en.wikipedia.org/wiki/Water_pipe#Difference_between_pipes_and_tubes.